Casio PV-S450 Manual do Utilizador

127Chapter11Data CommunicationData communications capabilities let you transfer data between two CASIO PVUnits, between a PV Unit and a BN-10/BN-20 Un

136• Transferring data from the PV-S250/PV-S450 to the BN Unit causes alleuro symbols to be replaced by spaces.• The following shows the relationship

137Chapter 11 Data Communication4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradleto the other unit’s cable.To make communicatio

1386. Tap the buttons under Parity, Bit length, and BPS to make the settingsyou want.• Note that the settings you make here must match those of the co

139Chapter 11 Data CommunicationNotes• Data communication can be interrupted at any time by tapping Esc.This causes the message Stopped! to appear on

128To detach the PV Unit from the cradle1. Turn off PV Unit power.2. Angle the PV Unit forward as shown in the illustration, and then lift itstraight

129Chapter 11 Data CommunicationData Communications Between Two PV UnitsThis section describes how to set up and communicate between two PV Units.To c

1303. Tap the Menu Bar icon to display the menu bar, and then tap System –Data communication.4. Tap the button next to Pocket Viewer to specify the da

131Chapter 11 Data CommunicationTo receive data from the terminal unit on the host unit1. Perform steps 1 through 4 under “To send data from the host

132Notes• The above procedures can be used to send or receive all data in specificmodes only. You cannot send or receive individual data items.• Data

133Chapter 11 Data Communication4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradleto the BN Unit Mini Cradle.• All data communic

1344. Tap the button next to BUSINESS NAVIGATOR to specify the datacommunication configuration.5. Tap the button next to Send.6. Tap Set.7. Tap the ch

135Chapter 11 Data CommunicationTo receive data from the BN Unit on the PV Unit1. Perform steps 1 through 4 under “To send data from the PV Unit to th