Casio E-Con EA-200 Guia do Utilizador descarregar pdf (Página 15)

20031201

2-5

Basic Steps for Configuring Sampling Parameters

k Photogate Sensor Parameters

Connection of a Vernier Photogate to the EA-200 requires configuration of parameters that

are different from those for other types of sensors.

u To configure a setup for Photogate alone

In step (3) of the procedure under “To configure parameters for sampling with a single

sensor” on page 2-1, select [Photogate] on the [Vernier] tab for the sensor. This causes the

parameters described below to appear on the Sensor Setup window that appears in step (4).

Parameter Initial Default Description

(Channel) SONIC CH1: Select this option when the Photogate

sensor is connected to CH1.

SONIC: Select this option when the Photogate

sensor is connected to SONIC.

Gate Status Open-Open Open-Open: Timing starts when the gate opens, and

continues until it closes and then opens

again.

Open-Close: Timing starts when the gate opens, and

continues until it closes.

Close-Open: Timing starts when the gate closes,

and continues until it opens.

Close-Close: Timing starts when the gate closes,

continues until it opens, and then closes

again.

Number of Samples 10 Input an integer in the range of 1 to 1000 to

specify the number of samples.

Store List Folder EConSamp Specify the variable folder for storage of interval data

Data and count data.

Interval Interval Input a variable name up to eight characters long for

storage of interval data.

Count Count Input a variable name up to eight characters long for

storage of count data.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 80 81

Sem comentários

Casio E-Con EA-200 Guia do Utilizador Página 15