Casio E-Con EA-200 Manual do Utilizador descarregar pdf (Página 6)

20021201

2-4

Using the Setup Wizard

4. Input an integer in the range of 1 to 255 to specify the number of samples.

5. Perform step 8 under “To configure an EA-200 setup using Setup Wizard” on page 2-2 to

finalize the procedure.

u To configure a setup for PhotoGate and Smart Pulley

1. Perform the first three steps of the procedure under “To configure an EA-200 setup using

Setup Wizard” on page 2-2.

2. On the “Select Sensor” screen, select [VERN] - [P-Gate] - [Pulley].

• This causes an “Input Distance(m)” screen to appear.

• The distance you specify here is the distance the weight travels after it is released.

• Input a value in the range of 0.1 to 4 to specify the distance in meters.

3. Perform step 8 under “To configure an EA-200 setup using Setup Wizard” on page 2-2 to

finalize the procedure.

k Outputting the Waveform of a Function through the Speaker

Normally, the Setup Wizard helps you configure setups for sensors connected to the EA-200.

If you select [CASIO] - [SPEAKR] - [Y=f(x)] on the “Select Sensor” screen, however, it

configures the EA-200 to output the sound that corresponds to a function that you input and

graph on the calculator.

u To configure a setup for speaker output

1. Connect the data communication cable (SB-62) to the communication port of the

calculator and the MASTER port of the EA-200.

2. Display the E-CON main menu (page 1-1), and then press 1(Setup EA-200).

• This displays the “Setup EA-200” submenu.

3. Press b(Wizard). This displays the Setup Wizard initial screen.

3. Use function keys 1 through 4 to select a Gate Status setting.

• Selecting a gate status causes a screen for specifying the number of samples to appear.

1 2 3 4 5 6 7 8 9 10 11 ... 48 49

Sem comentários

Casio E-Con EA-200 Manual do Utilizador Página 6