
Using the Setup Menu
16
Using the Setup Menu
Pressing the [MENU] key while an image is being projected displays the setup menu on the
projected image. The setup menu can be used to configure a variety of different projector
settings. The following table shows the menu items that are available in the Setup Menu.
Setup Menu Overview
Main menu Sub-menu Sub-menu Item Type
∗1
Input source
∗2
See page
RCSV –
Image
Adjustment
Brightness Value Setting 27
Contrast Value Setting 27
Sharpness Value Setting 27
Saturation Value Setting 27
Tint Value Setting ∗3 ∗327
Color Mode Setting Screen 28
Color Balance Setting Screen 28
Restore Menu Defaults Execution 29
Signal
Settings
Vertical Position Value Setting
∗5
30
Horizontal Position Value Setting
∗5
30
Frequency Value Setting
∗5
30
Phase Value Setting
∗5
30
Noise Filter Selection
∗5
31
Restore Menu Defaults Execution
∗5
31
Screen
Settings
Keystone Correction Value Setting 31
Aspect Ratio Selection ∗432
Resize Image To Fit Selection 33
Projection Mode Selection 34
Ceiling Mount
∗11 Selection 34
Restore Menu Defaults Execution 35
∗1 This is the sub-menu item type. Refer to the pages noted below for more information.
Value Setting: Specifies a numeric value () page 22).
Selection: Allows selection from multiple options () page 22).
Setting Screen: Numeric value specification or option selection on a separate setting
screen () page 23).
Execution: Initializes a setting () page 24).
Information: Displays information only () page 24).
∗2 These columns indicate whether each item appears ( ) or not ( ) for each input
source (R = RGB, C = Component, S = S-VIDEO, V = Video, – = No input signal).
∗3 This setting can be configured only for an NTSC or NTSC4.43 signal.
∗4 This setting can be selected only when the aspect ratio of the input signal is 4:3.
∗5 This setting or operation is available only when digital zoom is not being used.
Comentários a estes Manuais